← Back to All Articles
Machine Vision & Industrial Quality••10 min read

3D Laser Weld-Bead Inspection Using Cognex L38 & Siemens SIMATIC HMI: Shop-Floor Guide

3D laser weld-bead inspection with Cognex L38 works by capturing a laser profile across the weld and evaluating bead geometry against defined inspection criteria. A production-ready system must synchronize the profiler with part position, confirm trigger and result handshakes with the PLC, and present inspection state clearly to operators. Napeans Technologies documented this approach for an EBW machine shop using Work Loader servo positioning and Siemens SIMATIC HMI. The implementation paired profile acquisition with OK/NG decisions and controlled pusher handling, so the vision result became part of the production sequence. Thresholds, sampling, and acceptance criteria must be validated on representative welds and the actual line.

By Napeans Engineering Team

Practical hardware and PLC architecture

The EBW station combines a Cognex L38 3D laser profiler, servo-positioned work loading, Siemens PLC handshakes, and SIMATIC HMI controls for an integrated weld inspection sequence.

  • Cognex L38 profiler acquires the weld-bead profile while the Work Loader servo positions the part at the configured inspection locations: +216 mm middle and +498.5 mm advance.
  • The PLC coordinates VISION TRG, VISION OK, and VISION NG handshakes and sequences the inspection result with station operation.
  • Siemens SIMATIC HMI screens cover Main, Loading/Unloading Manual Operation, Work Loader, and Work Type Selection.
  • Operator controls include real-time EBW OK/NG indicators, EBW PROGRAM selection columns, live WK COUNT, OUT SHUTTLE and JOG MODE, and OK/NG PUSHER actions.
  • The documented HMI controls map to DB50 and DB200 PLC addresses; validate address mapping against the specific machine program before re-use.

Numbered implementation steps

  1. Define weld criteria and sampling

    Agree on the bead features to measure, inspection locations, acceptable ranges, sample variation, and how quality engineers will validate borderline welds.

  2. Mount and position the profiler

    Install the Cognex L38 with a stable view of the weld and coordinate acquisition with the Work Loader servo and actual part geometry.

  3. Coordinate the PLC handshake

    Sequence VISION TRG, busy/completion states, and VISION OK or VISION NG results so the PLC knows when a profile is valid and how to route the part.

  4. Design the SIMATIC HMI workflow

    Present program selection, work count, shuttle and jog modes, inspection status, manual operation, and pusher controls with clear operator permissions.

  5. Validate profiles and line handling

    Run representative good and suspect welds, confirm positioning and result repeatability, and test OK/NG routing and recovery with production teams.

Frequently asked questions

What does a Cognex L38 3D laser profiler measure on a weld bead?

A 3D laser profiler captures a cross-sectional profile that can be evaluated for configured weld geometry characteristics. The specific measurements and acceptance limits must be set and validated for the part and process.

How does a Siemens PLC coordinate a 3D vision inspection?

The PLC sequences the trigger, confirms profile acquisition and result validity, receives the inspection status, and controls the configured production response such as OK/NG routing.

What belongs on a SIMATIC HMI for weld inspection?

Useful screens can include work type and program selection, live inspection status, counters, manual loading and unloading, machine modes, shuttle status, and controlled OK/NG handling.

Can Cognex L38 weld inspection be synchronized with servo positioning?

Yes. The inspection sequence can coordinate profiler acquisition with defined servo positions. The motion points and capture timing must be confirmed for the machine and part.